Chapter 2-First Time Installation and Configuration
Unpacking the RMX
2-6
Unpacking the RMX 1500
To unpack and lift the RMX 1500:
1
When you receive the RMX 1500 packing case, inspect the equipment
for damage and verify that the components match the packing slip.
2
Open the top cover of the packing case.
Two boxes are placed on the top Stratocell®, labeled:
— Installation Accessories. This kit contains the power cables and a
USB key.
— Rack Installation Accessories. This kit contains the accessories for
the 19"/23" racks as follows:
Write down the RMX's serial number that is on a sticker on the back of the unit.
It will be needed for product registration later in the process.
Table 2-2
19" & 23" Rack Installation Accessories Package
Item ID
MEC2791A-L0
Unpacking the RMX 2000
To unpack and lift the RMX 2000:
1
When you receive the RMX 2000 packing case, inspect the equipment
for damage and verify that the components match the packing slip.
2
Open the top cover of the RMX 2000 packing case and make sure that
the Installation Accessories kit contains the power cables and a USB
Key.
3
Remove the top cover, lift the RMX 2000 from the package and place
it on a flat surface.
Write down the RMX's serial number that is on a sticker on the back of the unit.
It will be needed for product registration later in the process.
Description
Chassis runner (60cm in length) for
rack installation on the RMX 1500.
19"/23" racks both require that these
runners be installed on the rack.
Quantity
2