Doesn't operate at all:
Items to check
Is the Power Supply Plug disconnected its outlet?
Has there been a power failure?
Has a fuse blown out, or a circuit breaker been tripped?
• Is the timer operating?
Poor Cooling or Heating
Is the air filter dirty?
Air the air conditioner's intake grille or outlet port blocked?
Did you adjust the room temperature settings (thermostat)
Is there a window or door open?
In the case of Cooling operation, is a window allowing bright sun
light to enter? (Close the curtains.)
In the case of Cooling operation, are there heating apparatus and
computers inside the room, or are there too many people in the
The unit operates
differently from the Remote
Control Unit's setting:
Is the unit set for SUPER QUIET operation?
Are the Remote Control Unit's batteries dead?
Are the Remote Control Unit's batteries loaded properly?
If the problem persists after performing these checks, or if you notice burning smells, or the TIMER indicator lamp (Fig. 3
flashes, immediately stop operation, disconnect the Power Supply Plug (Fig. 1 @), and consult authorized service personnel.
( Operation and Performance
Microcomputer-controlled Automatic Defrosting
• When using the Heating mode under conditions of low outdoor temperature and high humidity, frost may form on the
outdoor unit, resulting in reduced operating performance.
In order to prevent this kind of reduced performance, this unit is equipped with a Microcomputer-controlled Automatic
Defrosting function. If frost forms, the air conditioner will temporarily stop, and the defrosting circuit will operate briefly (for
about 7-15 minutes).
During Automatic Defrosting operation, the OPERATION indicator lamp (red) will flash .
• The air conditioner power has been interrupted by a
power failure. The air conditioner will then restart auto
matically in its previous mode when the power is restored.
• Operated by setting before the power failure.
• If a power failure occurs during TIMER operation, the timer
will be reset and the unit will begin (or stop) operation at the
new time setting. In the event that this (kind of timer fault
occurs the TIMER Indicator Lamp will flash (see Page. 3».
• Use of other electrical appliances (electric shaver, etc.) or
nearby use of a wireless radio transmitter may cause the
air conditioner to malfunction. In this event, temporarily
disconnect the Power Supply Plug, reconnect it, and then
use the Remote Control Unit to resume operation.