Download Print this page

Fujitsu ASU9CQ Operating Manual page 32

Heat&coqling model (reverse cycle) room air conditioner wall mounted
Hide thumbs

Advertisement

Table of Contents
920-007-14
WallMaster chassis installation instructions for WS, WE and WY models
(WSC-B sleeve)
These instructions are provided for installation of WallMaster air
conditioner chassis models into thru-the-wall sleeves. This chassis
has been UL approved with the sleeve listed on the serial nameplate
of this chassis. Important warranty information is provided on pages
17 and 18. Keep these instructions in a convenient location for any
warranty service that may be required.
STEP 1 Check the sleeve to be certain it has been correctly installed
in the wall. Remove the corrugated front panel on the WSC
SLEEVE. Remove the rear WEATHER PANEL. Place lower
edge into sleeve tab (Friedrich logo facing out). Align slots
wffh
screw
holes. Secure grille wffh screws.
A.
Check the anchor screws. There should be four
(4) in the WSC SLEEVE (two in
each
side).
B.
Determine ifthe sleeve has adownward slope,
to the outside, of
%
bubble on a level. See
page 10 for further details.
C.
Check to be sure the sleeve has been sealed
around aU edges with an industrial type
caulking on both the outside and inside to
prevent rain entry.
D.
A sleeve sealing gasket has been provided
in the chassis shipping carton. Remove it
from the carton, peel the protective coating
from the adhesive, and install
it
in the sleeve
(adhesive down).
Figure 10
STEP 2
Check the electrical receptacle to see that it conforms to
the requirements for the chassis model to be installed.
See pages 2 and 5, for the receptacle requirements.
STEP 3
The decorative front is packaged in aseparate box inside
the chassis shipping carton, between the chassis and
the carton. Remove this box and set the box aside until
later.
STEP 4
With the help of an assistant, remove the chassis from
the shipping carton. Be careful not to allow anything to
impact against the hairpins as this may result in damage
to them. With the help of an assistant, lift the chassis by
the basepan and slide it into the sleeve until it contacts
the rear grille. With the chassis in proper position, the
front edge of the basepan must extend out 4 % inches
from the front (side) edge of sleeve.
Excessive Weight Hazard
Us. two or more people when
inslaling your air conditioner.
Failure to do so can result in
back
or
other
injury.
It
Cut/Sever
Although great care has been
taken to
minimize
sharp edges
in the
construction
of your
unit.
use gloves or other hand
protection
when handling unil
Fa~ure
to do
$0 ....
l1!SuIt in minor
to moderate personal
Injury.
Rear weather panel
13

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for Fujitsu ASU9CQ

  Related Manuals for Fujitsu ASU9CQ

This manual is also suitable for:

Asu12cqAou9cqAou12cq