Download Print this page

To Select Mode Operation; To Set The Thermostat; To Set The Fan Speed; To Stop Operation - Fujitsu ASU9CQ Operating Manual

Heat&coqling model (reverse cycle) room air conditioner wall mounted
Hide thumbs

Advertisement

Table of Contents
OPERATION
To Select Mode Operation
Press the START / STOP button (Fig.6 @).
1
The indoor unit's OPERATION indicator lamp (red) (Fig. 3
®)
will light.
The air conditioner will start operating.
2
Press the MASTER CONTROL button (Fig.6 @») to se ­
lect the desired mode.
Each time the button is pressed, the mode will change in the following
order.
r
AUTO ----+ COOL
---J>
DRY
~
L -_ _ _ _
FAN ....- - - - - - '
Example: When set to COOL.
About three seconds later, the entire display will reappear.
To Set the Thermostat
Press the SET TEMP./ SET TIME buttons (Fig. 6 @»).
button: Press to raise the thermostat setting.
e
button: Press to lower the thermostat setting.
.Thermostat setting range:
AUTO .................................. 64 to 88 OF
Cooling/Dry ........................ 64 to 88 OF
The thermostat cannot be used to set room temperature during the
FAN mode (the temperature will not appear on the remote control
unit's display).
About three seconds later, the entire display will reappear.
B6'F
The thermostat setting should be considered a standard value, and may differ
Example: When set to
86
OF.
somewhat from the actual room temperature.
To Set the Fan Speed
Press the FAN CONTROL button (Fig. 6 @).
Each time the button is pressed, the fan speed changes in the following order:
CAUTO----+ HIGH--+ MED----+LOW--+ QUIET"]
About three seconds later, the entire display will reappear.
When set to
AUTO:
-
Cooling
As the room temperature approaches that of the thermostat setting,
the fan speed becomes slower.
Fan
The fan runs at the low fan speed.
The fan will operate at a very low setting during Monitor operation
and at the start of the Heating mode.
When set to
QUIET:
SUPER QUIET operation begins. The indoor unit's airflow will be reduced for qui-
Example: When set to AUTO.
eter operation .
• SUPER QUIET operation cannot be used during Dry mode. (The same is true
when dry mode is selected during AUTO mode operation.)
• Heating and Cooling performance will be reduced somewhat during SUPER QUIET
operation.
Press the START/STOP button (Fig.6 @).
The OPERATION indicator lamp (red) (Fig. 3 (0) will go out.
En-5

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for Fujitsu ASU9CQ

  Related Manuals for Fujitsu ASU9CQ

This manual is also suitable for:

Asu12cqAou9cqAou12cq