Removing An I/O And Cmm System Board - TYAN MicroServer Series User Manual

7.9 Removing an I/O and CMM System Board

CAUTION:
!
Most repairs to the Tyan MicroServer should only be performed by a professional
service technician. Basic repairs and troubleshooting can be done if authorized in
the product documentation or if directed by telephone or online support from
Tyan. If damage has occurred due to repairs or service that is not approved by
Tyan, the product warranty becomes invalid. Review all safety guidelines that are
provided with the Tyan MicroServer.
CAUTION:
!
For cooling purposes, when the Pass-through / CMM module removed, it should
be immediately replaced with another Pass-through / CMM module for proper
cooling and air circulation to occur.
Prerequisite:
1. Remove five (5) screws from the Pass-through-M1902F65-CMMPT system board.
(Figure 5-6)
2. Slightly lift the rear of the system board.
3. Pull and remove the system board from the Pass-through-M1902F65-CMMPT blade.
Gigabit LAN
Port Slots
Figure 5-6. Removing the Pass-through-M1902F65-CMMPT Module System
Board
Power down the system.
Disconnect all cables and peripherals from the Pass-through / CMM module.
Remove the Pass-through / CMM module.
CMM Module.
http://www.tyan.com
Refer to Removing Pass-through /
I/O and CMM
System Board
Pass-through /
Blade
Management
Por t Slot