Hard Drives - TYAN MicroServer Series User Manual

6.5 Hard Drives

Installing a Hard-Drive
Prerequisite:
1. Remove hard-disk drive bracket from the blade.
2. Align and place the hard drive bracket with the hard drive. (Figure 4-5)
3. Secure the hard drive to the hard drive bracket with four (4) screws.
4. Position and align the bracket flange with the compute blade. (Figure 4-6)
5. Place the hard drive assembly on the compute blade.
6. Install and secure the hard drive assembly with two (2) screws.
7. Install the compute blade into the chassis. Refer to
Power down the system.
Disconnect all cables and peripherals from the compute blade(s).
Remove the compute blade. Refer to
Figure 4-5. Installing a Hard Drive Bracket
Figure 4-6. Installing a Hard Drive Module
http://www.tyan.com
Removing a Compute Blade.
Hard Drive
Bracket
Bracket Flange
Installing a Compute Blade.