Chapter 5: Chassis Management Module; Acquiring An Ip Address - TYAN MicroServer Series User Manual

This chapter provides information about the chassis management console. To login remotely
into the chassis management module (CMM) and access the console, you must first acquire
the CMM's IP address.

5.1 Acquiring an IP Address

This section provides information in order to acquire an IP address for use in setting up and
configuring the Chassis Management Module (CMM).
Before you start, make sure all compute blades and the CMM are connected to the network
through a DHCP server (recommended).
1. Power up the MicroServer.
All MicroServer blades are powered on by the system through the BMC.
2. Connect a monitor and keyboard to an active compute blade. See "FM65-B5519 Blade" on
page 6 for port locations.
3. In the POST screen, navigate to Server Management and look for the compute blade
BMC IP address
NOTE: NOTE:
Note the BMC IP address is assigned by the DHCP server.
4. Connect a remote computer to the same network used by the MicroServer.
5. In the remote computer, open a browser and in the address bar type the BMC IP (See step
3).
6. In the login screen, type in the following username and password for both CMM and BMC.
username: root
password: superuser
Figure 3-1. Login Menu
NOTE:
NOTE:
Passwords are case sensitive.

Chapter 5: Chassis Management Module

http://www.tyan.com