Removing A Power Supply Module; Installing A Power Supply Module - TYAN MicroServer Series User Manual

7.3.1 Removing a Power Supply Module

CAUTION:
!
Most repairs to the Tyan MicroServer should only be performed by a professional
service technician. Basic repairs and troubleshooting can be done if authorized in
the product documentation or if directed by telephone or online support from
Tyan. If damage has occurred due to repairs or service that is not approved by
Tyan, the product warranty becomes invalid. Review all safety guidelines that are
provided with the Tyan MicroServer.
CAUTION:
!
Make sure that the power cable is disconnected from the power supply module
(PSU) before attempting to remove the PSU.
1. Disconnect the power cable from the power supply module socket. (Figure 5-2)
2. Press and hold the release latch on the power supply module.
3. Pull the handle on the power supply module to remove it from the chassis.

7.3.2 Installing a Power Supply Module

1. Install the power supply module into the chassis until the release latch locks and the
power supply module is seated properly with the chassis. (Figure 5-2)
2. Connect the power cable into the power supply module socket.
Module
Handle
handle
Figure 5-2. Removing a Power Supply Module
http://www.tyan.com
Power Supply
Socket
Release
Latch