Pass-Through-M1902F65-Cmmpt Module; Removing Pass-Through-M1902F65-Cmmpt Module; Installing Pass-Through-M1902F65-Cmmpt Module - TYAN MicroServer Series User Manual

7.6 Pass-through-M1902F65-CMMPT Module

CAUTION:
!
Most repairs to the Tyan MicroServer should only be performed by a professional
service technician. Basic repairs and troubleshooting can be done if authorized in
the product documentation or if directed by telephone or online support from
Tyan. If damage has occurred due to repairs or service that is not approved by
Tyan, the product warranty becomes invalid. Review all safety guidelines that are
provided with the Tyan MicroServer.
CAUTION:
!
For cooling purposes, when the Pass-through / CMM module removed, it should
be immediately replaced with another Pass-through / CMM module for proper
cooling and air circulation to occur.
Prerequisite:

7.7 Removing Pass-through-M1902F65-CMMPT Module

1. Press and hold the release latch on the Pass-through / CMM module. (Figure 5-5)
2. Pull the handle on the Pass-through / CMM module to remove it from the chassis.

7.8 Installing Pass-through-M1902F65-CMMPT Module

1. Install the Pass-through / CMM module into the chassis until the release latch locks and
the module is seated properly with the chassis. (Figure 5-5)
Power down the system.
Disconnect all cables and peripherals from the Pass-through / CMM module.
Release
Latch
Figure 5-5. Removing a Pass-through / CMM Module
http://www.tyan.com
Handle