Chapter4: Mounting The System Into A 4-Post Rack; Preparing For The Installation; Installing The Inner Rail - TYAN MicroServer Series User Manual

After installing the necessary components, the Tyan MicroServer can be mounted in a 4-post
rack using the optional rail kit.
The rail kit includes the following items:
(2) Rail kit assemblies

(1) Set of screws


4.1 Preparing for the Installation

Review all the tasks required to install and configure the system.

Review the electrical requirements and power supply input voltage information.

Examine the system's shipping kit contents and assemble the required tools for

installation.
Review ESD requirements and take safety precautions.

Before installing the system into a rack, install any optional components into the

system.
Stabilize the rack before installing the system, if necessary.


4.2 Installing the Inner Rail

WARNING:
!
Use caution when removing the inner rail from the rail kit assembly. The rails
can slide out and cause personal injury or damage to the TYAN MicroServer.
1. Remove the inner rail from the rail kit assembly.
2. Align and insert the holes on the inner rail into the pins on the side of the chassis.
(Figure 2-10)
3. Slide the inner rail until the latch key on the rail locks and is secure to the chassis.
4. Repeat steps 1 through 3 for the remaining side.

Chapter4: Mounting the System into a 4-Post Rack

Figure 2-10. Installing the Inner Rail
http://www.tyan.com
Inner Rail
Latch Key