Compute Blade Modules; Removing A Compute Blade; Installing A Compute Blade - TYAN MicroServer Series User Manual

Tyan microserver series

Hide thumbs Also See for MicroServer Series:

Table of Contents

6.4.3 Compute Blade Modules

CAUTION:

Most repairs to the Tyan MicroServer should only be performed by a professional

service technician. Basic repairs and troubleshooting can be done if authorized in

the product documentation or if directed by telephone or online support from

Tyan. If damage has occurred due to repairs or service that is not approved by

Tyan, the product warranty becomes invalid. Review all safety guidelines that are

provided with the Tyan MicroServer.

CAUTION:

For cooling purposes, when a compute blade is removed, it should be

immediately replaced with another compute blade for proper cooling and air

circulation to occur.

Prerequisite:

1. Press and hold the release latch on the compute blade. (Figure 4-3)

2. Pull the handle on the compute blade to remove it from the chassis.

Handle

1. Remove the new compute blade module from the packaging.

2. Align the new compute blade module to the chassis bay. (Figure 4-3)

3. Install the compute blade into the chassis until the release latch locks and the compute

blade is seated properly with the chassis.

Disconnect all cables and peripherals from the compute blade(s).

Release

Latch

Figure 4-3. Removing a Compute Blade

http://www.tyan.com

Table of Contents

Fm65-b5519