Installing The Outer Rail - TYAN MicroServer Series User Manual

4.3 Installing the Outer Rail

WARNING:
!
Use caution when installing the outer rail. The middle rail, which is attached to the
outer rail, can slide out and cause personal injury or damage to the system.
1. Align and place the front mounting bracket of the outer rail on the front cabinet column of
the rack. (Figure 2-11)
2. Extend the length of the outer rail until the rail reaches the rear cabinet column of the rack
3. Align and place the rear mounting bracket on the rear cabinet column of the rack.
NOTE: NOTE:
4. Secure the outer rail to the rack with the screws and washers to the front and rear of the
rack.
NOTE: NOTE:
The outer rails contain the words "FRONT" and "REAR". The "FRONT" of the outer rail
must be placed towards the front of the rack and "REAR" must be placed towards the
rear.
CAUTION:
!
Both outer rails must be aligned evenly or the chassis cannot be installed to the
rack. Use a ruler to ensure that both rails are evenly aligned in a 180 degree
angle.
5. Repeat steps1 through4 for the opposite side.
Front Cabinet
Column
Figure 2-11. Installing the Outer Rail
http://www.tyan.com
Outer Rail
Rear Cabinet
Column