Wan Connection Configuration; Wan Interface - ZyXEL Communications P-2812HNU-51c User Manual

Chapter 5 WAN Setup
Table 17 Internet Connection
LABEL
Type
Rate
Vlan8021p
VlanMuxId
ConnId
IGMP
NAT
Firewall
Modify
Add

5.5.1 WAN Connection Configuration

Click the Edit or Add button in the WAN Service screen to configure a WAN
connection.

5.5.1.1 WAN Interface

This screen displays when you add a new WAN connection.
Figure 35 WAN Configuration: WAN Interface
98
DESCRIPTION
This shows the layer-2 interface type and method of encapsulation
used by this connection.
IPoW stands for IPoE used in an Ethernet WAN connection.
This shows the maximum data rate (in Kbps) allowed for traffic sent
through this connection. This displays N/A when there is no limit on
transmission rate.
This indicates the 802.1P priority level assigned to traffic sent through
this connection. This displays N/A when there is no priority level
assigned.
This indicates the VLAN ID number assigned to traffic sent through
this connection. This displays N/A when there is no VLAN ID number
assigned.
This shows the index number of each connection. This displays N/A
when the interface used by the connection is in Default Mode.
This shows whether IGMP (Internet Group Multicast Protocol) is
activated or not for this connection. IGMP is not available when the
connection uses the bridging service.
This shows whether NAT is activated or not for this interface. NAT is
not available when the connection uses the bridging service.
This shows whether the firewall is activated or not for this connection.
The firewall is not available when the connection uses the bridging
service.
Click the Edit icon to configure the WAN connection.
Click the Remove icon to delete the WAN connection.
Click Add to create a new connection.
P-2812HNU-51c User's Guide