Firmware Specifications - ZyXEL Communications P-2812HNU-51c User Manual

Chapter 27 Product Specifications

27.2 Firmware Specifications

Table 112 Firmware Specifications
Default IP Address
Default Subnet Mask
Default User Name
Default Password
DHCP Server IP Pool
Static Routes
Device Management
Wireless
Functionality
(wireless devices
only)
Firmware Upgrade
Configuration Backup
& Restoration
Port Forwarding
DHCP (Dynamic Host
Configuration
Protocol)
Dynamic DNS
Support
IP Multicast
Time and Date
Logs
Universal Plug and
Play (UPnP)
316
192.168.1.1
255.255.255.0 (24 bits)
admin
1234
192.168.1.33 to 192.168.1.132
16
Use the web configurator to easily configure the rich range of
features on the P-2812HNU-51c.
Allow the IEEE 802.11b, IEEE 802.11g and/or IEEE 802.11n
wireless clients to connect to the P-2812HNU-51c wirelessly.
Enable wireless security (WEP, WPA(2), WPA(2)-PSK) and/or MAC
filtering to protect your wireless network.
Download new firmware (when available) from the ZyXEL web site
and use the web configurator to put it on the P-2812HNU-51c.
Note: Only upload firmware for your specific model!
Make a copy of the P-2812HNU-51c's configuration. You can put it
back on the P-2812HNU-51c later if you decide to revert back to
an earlier configuration.
If you have a server (mail or web server for example) on your
network, you can use this feature to let people access it from the
Internet.
Use this feature to have the P-2812HNU-51c assign IP addresses,
an IP default gateway and DNS servers to computers on your
network. Your device can also act as a surrogate DHCP server
(DHCP Relay) where it relays IP address assignment from the
actual real DHCP server to the clients.
With Dynamic DNS (Domain Name System) support, you can use
a fixed URL, www.zyxel.com for example, with a dynamic IP
address. You must register for this service with a Dynamic DNS
service provider.
IP multicast is used to send traffic to a specific group of
computers. The P-2812HNU-51c supports versions 1 and 2 of
IGMP (Internet Group Management Protocol) used to join
multicast groups (see RFC 2236).
Get the current time and date from an external server when you
turn on your P-2812HNU-51c. You can also set the time manually.
These dates and times are then used in logs.
Use logs for troubleshooting. You can send logs from the P-
2812HNU-51c to an external syslog server.
A UPnP-enabled device can dynamically join a network, obtain an
IP address and convey its capabilities to other devices on the
network.
P-2812HNU-51c User's Guide