ZyXEL Communications P-2812HNU-51c User Manual page 256

Chapter 18 Remote Management
Click Advanced > Remote MGMT to open the following screen. Use this screen
to configure your P-2812HNU-51c to be managed by an ACS.
Figure 117 TR-069
The following table describes the fields in this screen.
Table 87 TR-069
LABEL
Inform
Inform Interval
ACS URL
ACS User Name
ACS Password
WAN Interface
used by TR-069
client
Display SOAP
messages on
serial console
Connection
Request
Authentication
256
DESCRIPTION
Select Enable to activate remote management via TR-069 on the
WAN. Otherwise, select Disable.
Enter the time interval (in seconds) at which the P-2812HNU-51c
sends information to the auto-configuration server.
Enter the URL or IP address of the auto-configuration server.
Enter the TR-069 user name for authentication with the auto-
configuration server.
Enter the TR-069 password for authentication with the auto-
configuration server.
Select a WAN interface through which the TR-069 traffic passes.
If you select Multi_WAN, you should also select the pre-configured
WAN connection(s).
Select Enable to show the SOAP messages on the console.
Select this option to enable authentication when there is a connection
request from the ACS.
P-2812HNU-51c User's Guide