ZyXEL Communications P-2812HNU-51c User Manual page 132

Chapter 7 Wireless LAN
Table 28 Network > Wireless LAN > General
LABEL
Bandwidth
Control
Sideband
Network
Name (SSID)
Hide Network
Name (SSID)
Enable
Wireless
Multicast
Forwarding
(WMF)
BSSID
Security
Mode
MAC Filter
132
DESCRIPTION
Select whether the P-2812HNU-51c uses a wireless channel width of
20MHz or 40MHz.
A standard 20MHz channel offers transfer speeds of up to 150Mbps
whereas a 40MHz channel uses two standard channels and offers speeds
of up to 300 Mbps.
40MHz (channel bonding or dual channel) bonds two adjacent radio
channels to increase throughput. The wireless clients must also support 40
MHz. It is often better to use the 20 MHz setting in a location where the
environment hinders the wireless signal.
Select 20MHz if you want to lessen radio interference with other wireless
devices in your neighborhood or the wireless clients do not support
channel bonding.
This field is available only when you set the 802.11 Mode to 802.11n
Only or 802.11b/g/n Mixed in the Advanced Setup screen.
This is available for some regions when you select a specific channel and
set the Bandwidth field to 40MHz. Set whether the control channel (set
in the Channel field) should be in the Lower or Upper range of channel
bands.
This field is available only when you set the 802.11 Mode to 802.11n
Only or 802.11b/g/n Mixed in the Advanced Setup screen.
The SSID (Service Set IDentity) identifies the service set with which a
wireless device is associated. Wireless devices associating to the access
point (AP) must have the same SSID. Enter a descriptive name (up to 32
printable 7-bit ASCII characters) for the wireless LAN.
Note: If you are configuring the P-2812HNU-51c from a computer
connected to the wireless LAN and you change the P-
2812HNU-51c's SSID or wireless security settings, you will lose
your wireless connection when you press Apply to confirm. You
must then change the wireless settings of your computer to
match the P-2812HNU-51c's new settings.
Select this check box to hide the SSID in the outgoing beacon frame so a
station cannot obtain the SSID through scanning using a site survey tool.
Select this check box to allow the P-2812HNU-51c to convert wireless
multicast traffic into wireless unicast traffic.
This shows the MAC address of the wireless interface on the P-2812HNU-
51c when wireless LAN is enabled.
See the following sections for more details about this field.
Click this button to go to the MAC Filter screen to configure whether the
wireless devices with the MAC addresses listed are allowed or denied to
access the P-2812HNU-51c using this SSID.
P-2812HNU-51c User's Guide