ZyXEL Communications P-2812HNU-51c User Manual page 78

Chapter 4 Status Screens
Table 7 Status Screen
LABEL
ESSID
Status
Security
System Status
System
Uptime
Current
Date/Time
System
Mode
CPU Usage
Memory
Usage
Interface Status
Interface
Status
Rate
More Status
78
DESCRIPTION
This is the descriptive name used to identify the P-2812HNU-51c in this
wireless network. Click this to go to the screen where you can change
it.
This shows the current status of the wireless network.
This shows the level of wireless security the P-2812HNU-51c is using in
this wireless network.
This field displays how long the P-2812HNU-51c has been running since
it last started up. The P-2812HNU-51c starts up when you plug it in,
when you restart it (Maintenance > Tools > Restart), or when you
reset it (see Section 1.6 on page
This field displays the current date and time in the P-2812HNU-51c. You
can change this in Maintenance > System > Time Setting.
This displays whether the P-2812HNU-51c is functioning as a router or
a bridge.
This field displays what percentage of the P-2812HNU-51c's processing
ability is currently used. When this percentage is close to 100%, the P-
2812HNU-51c is running at full load, and the throughput is not going to
improve anymore. If you want some applications to have more
throughput, you should turn off other applications (for example, using
QoS; see Chapter 16 on page
This field displays what percentage of the P-2812HNU-51c's memory is
currently used. Usually, this percentage should not increase much. If
memory usage does get close to 100%, the P-2812HNU-51c is probably
becoming unstable, and you should restart the device. See
on page 298, or turn off the device (unplug the power) for a few
seconds.
This column displays each interface the P-2812HNU-51c has.
This field indicates whether or not the P-2812HNU-51c is using the
interface.
For the DSL interface, this field displays LinkDown (line is down) or Up
(line is up or connected).
For the LAN or Ethernet WAN interface, this field displays Up when the
P-2812HNU-51c is using the interface and NoLink when the line is
disconnected.
For the WLAN interface, it displays Up when WLAN is enabled or
Disabled when WLAN is not active.
For the DSL interface, it displays the downstream and upstream
transmission rate.
For the LAN or Ethernet WAN interface, this displays the port speed and
duplex setting.
For the WLAN interface, it displays the maximum transmission rate.
27).
239).
P-2812HNU-51c User's Guide
Section 24.4