ZyXEL Communications P-2812HNU-51c User Manual page 33

This example illustrates how to manually connect your wireless client to an access
point (AP) which is configured for WPA-PSK security and connected to the
Internet. Before you connect to the access point, you must know its Service Set
IDentity (SSID) and WPA-PSK pre-shared key. In this example, the SSID is
"SSID_Example3" and the pre-shared key is "ThisismyWPA-PSKpre-sharedkey".
After you install the ZyXEL utility and then insert the wireless client, follow the
steps below to connect to a network using the Site Survey screen.
Open the ZyXEL utility and click the Site Survey tab to open the screen shown
1
next.
Figure 9 ZyXEL Utility: Site Survey
The wireless client automatically searches for available wireless networks. Click
2
Scan if you want to search again. If no entry displays in the Available Network
List, that means there is no wireless network available within range. Make sure
the AP or peer computer is turned on or move the wireless client closer to the AP
or peer computer.
P-2812HNU-51c User's Guide
Chapter 2 Tutorials
33