Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for ZyXEL Communications P-2608HWL-DX
Summary of Contents for ZyXEL Communications P-2608HWL-DX
-
Page 1: Quick Start Guide
P-2608HWL-Dx 802.11g Wireless ADSL2+ VoIP IAD Quick Start Guide Version 3.40 10/2006 Edition 1... -
Page 2: Rear Panel
1 Make Your Hardware Connections Rear Panel 1 DSL: In the P-2608HWL-Dx, the DSL port handles both the ADSL and regular telephone service connections. Connect the v-shaped cable (with one gray and one green wire) to the P-2608HWL-Dx’s DSL port. Connect the gray wire to the MODEM or DSL jack on a telephone or ISDN splitter (not included) and the green wire to the splitter's TEL or PHONE jack. -
Page 3: Side Panel
• The WLAN LED turns on when the wireless LAN is ready. It blinks when the P-2608HWL-Dx is sending or receiving data through the wireless LAN. • The DSL LED blinks when the P-2608HWL-Dx is attempting to detect a carrier signal and it stays on if a con- nection is ready. - Page 4 P-2608HWL-Dx Quick Start Guide • The PHONE LEDs stay on when your SIP account is registered and they blink if the receiver is off the hook. If none of the LEDs are on, turn the device off and recheck your hardware connections.
- Page 5 3 Follow the directions in this screen. 3.1 Internet/Wireless Setup 1 Click INTERNET/WIRELESS SETUP. Wait while the P-2608HWL-Dx tries to detect your Internet connection. If the P-2608HWL-Dx cannot detect your Internet connection, follow the directions. Enter the information provided by your ISP.
-
Page 6: Voip Setup
You must enable OTIST on the P-2608HWL-Dx and all wireless clients within three minutes in any order. To start OTIST on the P-2608HWL-Dx, hold in the RESET button for three to five seconds. Do not hold the RESET button in for too long, as this will reset the P-2608HWL-Dx to the factory defaults. - Page 7 3.4 Regular Phone Line Setup When one of your VoIP accounts is registered, the P-2608HWL-Dx normally uses the Internet (not the regular phone line) to make phone calls. Follow the directions in this section to make sure you can also use the regular phone line while one of your VoIP accounts is registered.
-
Page 8: Make Phone Calls
• Otherwise, first dial the prefix you set in Section 3.4, and then dial the phone number. Follow these directions to call the phone that is connected to the P-2608HWL-Dx. • Use your VoIP service provider’s dialing plan, or just dial the phone number.