ZyXEL Communications P-2812HNU-51c User Manual page 100

Chapter 5 WAN Setup
Figure 37 WAN Configuration: Service Type: PPPoA or IPoA
The following table describes the labels in this screen.
Table 19 WAN Configuration: Service Type
LABEL
Select WAN
service type
Enter Service
Description
Rate Limit
Tag VLAN ID
for egress
packets
Enter 802.1P
Priority
Enter 802.1Q
VLAN ID
Back
Next
5.5.1.3 WAN IP Address and DNS Server
The screen differs by the encapsulation you selected in the previous screen. See
Section 5.6 on page 110
100
DESCRIPTION
Select the method of encapsulation used by your ISP.
Choices are PPP over Ethernet (PPPoE), IP over Ethernet and
Bridging.
Specify a name for this connection or use the automatically generated
one.
Enter the maximum transmission rate in Kbps for traffic sent through the
WAN connection. Otherwise, leave this field blank to disable the rate
limit.
This field is not available for an ATM connection.
Select this option to add the VLAN tag (specified below) to the outgoing
traffic through this connection.
This field is available when the layer-2 interface is in VLANMUX mode.
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into
a MAC-layer frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through
this connection. The greater the number, the higher the priority level.
This field is available when the layer-2 interface is in VLANMUX mode.
Type the VLAN ID number (from 1 to 4094) for traffic through this
connection.
This field is available when the PTM interface is in VLANMUX mode.
Click this button to return to the previous screen.
Click this button to continue.
for more information.
P-2812HNU-51c User's Guide