Date And Time; Ntp Time Synchronization; Connection Interval; Time Server Address - Xerox C75 System Administration Manual

Date and Time

Use the following instructions to setup the Date and Time for the printer.
1. Select Machine Status from the Control Panel.
2. Select the Tools tab, System Settings and select Common Service Settings.
3. Select Machine Clock/Timers.
4. Select Date and select Change Settings. Enter the Date Format and then the day,
month and year.
5. Select Save.
6. Select Time and select Change Settings. Select either 12 Hour Clock or 24 Hour
Clock. Then select the hours and select Save.

NTP Time Synchronization

You can get the time from a time server (NTP: Network Time Protocol), to synchronize
the machine to the time server time.
1. From the Machine Clock/Timers screen, select NTP Time Synchronization, and select
Change Settings.
2. Select On or Off.
3. Select Save to save the settings and return to the previous window.

Connection Interval

Select the time interval at which a connection is made to the time server.
Select an interval from 1 to 500 hours, in steps of one hour.
1. From the Machine Clock/Timers screen, select Connection Interval, and select Change
Settings.
2. Enter the Connection Interval using the numeric keypad.
3. Select Save to save the settings and return to the previous window.

Time Server Address

This is used to enter the IP address for the time server.
Note
Set the NTP Time Synchronization to on.
1. From the Machine Clock/Timers screen, select Time Server Address and press Change
Settings.
2. Enter the IP address:
IP Address: Set the IP address of the time server from which the time is obtained,
using values 0 to 255.
Addresses 244 to 255.XXX.XXX.XXX and 127.XXX.XXX.XXX cannot be set.
Xerox Color C75 Press
®
System Administration Guide
Common Service Settings
9-3