Adjusting Values; Power On Self Test; Usb Key - Xerox C75 System Administration Manual

Common Service Settings

Adjusting Values

Adjust the size (scale) of the image with respect to the lead edge direction and the side
edge direction according to the paper feed direction by 0.025% increments for each of
sides (side 1 and 2). You can adjust up to 0.400%. Specify a positive value when you
want to increase the scale, and a negative value when you want to reduce it.
1. Check the sample output, and measure the scale offset amount that occurred.
Paper feed direction: X direction scale
X direction scale offset amount = image reference length in the X direction - image
actual measurement length in the X direction
Vertical direction in relation to the paper feed direction: Y direction scale
Y direction scale offset amount = image reference length in the Y direction - image
actual measurement length in the Y direction
The reference lengths for a sample output of A3 or A4 size printed with Sample
Printout are as follows.
Paper Size Image Reference Length in X Direc-
tion
A3 400 mm
A4 190 mm
2. Select X% or Y%, and press Change Settings.
3. Enter the offset amount of the X direction scale you measured in Step 1 for Side 1
and Side 2 of X%.
4. Enter the offset amount of the Y direction scale you measured in Step 1 for Side 1
and Side 2 of Y%.
Note
If the scale offset amount is positive, enter a negative value in the adjustment value
field. If negative, enter a positive value.
5. Press Save.

Power On Self Test

1. Select Maintenance.
2. Select Power On Self Test.
3. Select either On or Off to determine if a self test will be printed when the printer is
powered on.

USB Key

1. The USB key feature must be enabled.
9-44
Image Reference Length in Y Direction
277 mm
277 mm
Xerox
®
System Administration Guide
Color C75 Press