Manual Alignment Adjustment Procedure - Xerox C75 System Administration Manual

Common Service Settings
If the alignment if okay, you are done and you can exit Administrator mode.
If the alignment is not okay, repeat the steps in this procedure.

Manual Alignment Adjustment procedure

1. Load paper in the desired tray.
2. Login as administrator.
a) Press the Log In/Out button on the control panel.
b) Enter the system administrator ID.
The default ID is admin, and the default password is 1111.
c) Select Enter.
3. Press the Machine Status button on the UI.
4. Select the Tools tab.
5. Select System Settings > Common Service Settings > Maintenance.
The Maintenance screen is displayed.
6. Using the down button, scroll to the next Maintenance page/screen.
7. Select Alignment Adjustment.
8. Select Manual Alignment Adjustment.
9. Select one of the available items (one that does not already have a profile created
and saved to it.)
10. Select Change Settings.
The Alignment Adjustment Setup screen displays.
11. Select Alignment Adjustment Type Setup.
12. Select Change Settings.
The Alignment Adjustment Type Setup screen displays.
13. Select an alignment item (Type 1-50) to set (create) or adjust (revise).
For the purposes of this procedure Type X represents Type 1-50.
14. Select Change Settings.
The Type X screen displays (for example Type 1).
15. Make the following selections:
a) Select Name and then Change Settings.
b) Enter a recognizable name (such Letter Size or A4).
c) Select Save to return to the Type X screen.
16. Select Sample Printout.
The Type X - Sample Printout screen displays.
17. Select the tray in which you loaded paper, and then select either 2 Sided or 1 Sided,
and the number of sheets.
18. Press Start on the control panel.
19. Retrieve and review the sample printout.
a) If the position of the sample output is correct, a line is printed at a position 10
mm from the edge of the paper.
9-28 Xerox Color C75 Press
®
System Administration Guide