Density Uniformity Adjustment - Xerox C75 System Administration Manual

16. Select Save.
17. Select Close until the Adjust Fold Position screen appears.
18. Select the tray in which you loaded paper in step 1, and then press the Start button.
19. Select the adjusted fold position type, and select Save.
20. Continue to select Save or Close until you are returned to the main Tools tab display.
21. Exit administrator mode.

Density Uniformity Adjustment

Use this feature to correct image quality on the output when that image quality is not
consistent throughout the entire output; for example, the image quality is lighter (faded)
or heavier (thicker) on the left/right sides of the output (inboard/outboard). This feature
uses a new application called Simple Image Quality Adjustment (SIQA), and it allows
the user to easily and quickly make adjustments and correct these image quality issues.
The procedure requires the installation of the SIQA (Simple Image Quality Adjustment)
application on a Windows ® PC.
Note
If your print server is a Windows-based PC, the SIQA application may be installed on it;
otherwise a third-party PC is required. Contact the Customer Support Center for more
information.
1. Record the IP address; this will be used later in the procedure.
a) If connected to a FreeFlow Print Server, obtain the IP address from the print engine
UI by selecting Machine Status > Machine Information. Record the IPv4 IP
address.
b) If connected to a standalone EX Print Server, obtain the print server IP address
either from the configuration sheet or by selecting Command Workstation >
Device Center > General.
c) If connected to an Integrated Fiery Color Server, obtain the print server IP address
from the configuration sheet.
2. From the print engine (machine) UI, login as administrator.
a) Press the Log In/Out button on the control panel.
b) Enter the system administrator ID.
The default ID is admin, and the default password is 1111.
c) Select Enter.
3. Press the Machine Status button on the UI.
4. Select the Tools tab.
5. Select System Settings > Common Service Settings > Maintenance.
The Maintenance screen is displayed.
6. Using the down button, scroll to the next Maintenance page/screen.
7. Select Density Uniformity Adjustment.
The Density Uniformity Adjustment screen is displayed.
8. Select Semi Auto Process Using Scanner.
Xerox Color C75 Press
®
System Administration Guide
Common Service Settings
9-41