Table of Contents
Advertisement
MAINTENANCE WORK ON CHASSIS AND ENGINE
Draining the gear oil
x
11.108
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the gear oil only when the engine is warm.
Refilling with gear oil
x
11.109
Info
Too little gear oil or poor-quality oil results in premature wear of the transmission.
–
Place the motorcycle on a level surface.
–
Place a suitable container under the engine.
(All 125/150/200 models)
–
Remove the gear oil drain plug with magnet
–
Remove the gear oil drain plug
–
Completely drain the gear oil.
–
Clean the gear oil drain plug thoroughly.
–
Clean the sealing area on the engine.
–
Mount the gear oil drain plug with magnet
Guideline
B00051-10
Gear oil drain plug with magnet
–
Mount gear oil drain plug
Guideline
Gear oil drain plug
(All 250/300 models)
–
Remove the gear oil drain plug with magnet
–
Completely drain the gear oil.
–
Thoroughly clean the gear oil drain plug with a magnet.
–
Clean the sealing area on the engine.
–
Mount the gear oil drain plug with magnet
Guideline
Gear oil drain plug with magnet
B00052-10
–
Remove screw cap
Gear oil
–
Mount and tighten the screw cap.
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
B00053-10
effective exhaust extraction system.
.
M12x1.5
with the seal ring and tighten it.
M10x1
M12x1.5
and fill up gear oil.
0.70 l (0.74 qt.)
Engine oil (15W/50) (
.
and the seal ring and tighten it.
20 Nm
(14.8 lbf ft)
15 Nm
(11.1 lbf ft)
.
and the seal ring and tighten it.
20 Nm
(14.8 lbf ft)
p. 130)
89
Advertisement
Table of Contents
