Installing The Glass Fiber Yarn Filling Of The Main Silencer; Changing The Glass Fiber Yarn Filling Of The Main Silencer; Removing The Air Filter Box Lid; Installing The Air Filter Box Lid - KTM 125 EXC EU 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Installing the glass fiber yarn filling of the main silencer

11.91
0 0 3 3
2 0 0 2

Changing the glass fiber yarn filling of the main silencer

11.92

Removing the air filter box lid

11.93

Installing the air filter box lid

11.94

Removing the air filter

x
11.95
Note
Engine failure Unfiltered intake air has a negative effect on the service life of the engine.
–
Never ride the vehicle without an air filter since dust and dirt can get into the engine and result in increased wear.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Slide the glass fiber yarn filling
4 0 0 4
–
Slide the outer tube
Info
Ensure that the O-rings are seated properly.
0 0 1 1 –
Insert locking cap
–
Mount and tighten nut
–
Install the main silencer. (
B00074-10
–
Remove the glass fiber yarn filling of the main silencer.
–
Install the glass fiber yarn filling of the main silencer.
B00063-00
–
Pull off the air filter box lid in area
B00038-10
–
Insert the air filter box lid into the rear area
B00038-11
–
Remove the air filter box lid. (
x
over the inner tube.

over the glass fiber yarn filling.

into the outer tube.

.

p. 80)
x
sideways and remove it toward the front.


p. 81)
( p. 80)
x
( p. 81)
x
and clip it into the front area
81
.
