Removing The Battery; 250 Exc Aus/Xc-W/Xc, All 300 Models); Installing The Battery; Recharging The Battery (250 Exc Aus/Xc-W/Xc, All 300 Models) - KTM 125 EXC EU 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Removing the battery

x
11.71
Warning
Risk of injury Battery acid and battery gases cause serious cauterization.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a doctor.

Installing the battery

(250 EXC AUS/XC‑W/XC, all 300 models)
x
11.72
Recharging the battery
x
11.73
Warning
Risk of injury Battery acid and battery gases cause serious cauterization.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a doctor.
Warning
Environmental hazard Battery parts and acid are harmful to the environment.
–
Do not discard batteries with the household trash. Dispose of a defective battery in an environmentally compatible manner.
Give the battery to your KTM dealer or to a recycling center that accepts used batteries.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
(250 EXC AUS/XC‑W/XC, all 300 models)
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
–
Disconnect the negative (minus) cable
–
Pull back the plus pole cover
tery.
–
Hang the rubber band
–
Lift the battery up.
500069-10
–
Place the battery in the battery holder.
Battery (YTX4L-BS) (
–
Reconnect the rubber band
–
Attach the plus cable and replace the plus pole cover
–
Attach the minus cable
–
Mount the seat. (
500069-11
(250 EXC AUS/XC‑W/XC, all 300 models)
p. 74)
of the battery.

and disconnect the positive (plus) cable of the bat-

out to the bottom.

p. 111)
.

.

p. 75)
72
.
