Table of Contents
Advertisement
MAINTENANCE WORK ON CHASSIS AND ENGINE
Installing the start number plate (XC‑W/XC)
11.34
Handlebar position
11.35
A
0 0 A
A
0 0 A
B
0 0 B
Adjusting the handlebar position
11.36
Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
1
0 0 1
2
0 0 2
–
Position the start number plate. Mount and tighten screw
Guideline
Remaining screws, chassis
Info
Ensure that the holding lugs engage in the fender.
–
Position the brake line. Put on the clamp and mount and tighten screw
500123-11
On the upper triple clamp, there are two holes a distance of
Hole distance A
The holes on the handlebar support are placed at a distance of
Hole distance B
0 0 B
B
The handlebar can be mounted in four different positions. In this way, the handlebar
can be mounted in the position that is most comfortable for the rider.
400223-11
x
–
Remove the four screws
1
0 0 1
and lay it to one side.
2
0 0 2
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove the two screws
–
Place the handlebar support in the required position. Mount and tighten the two
400223-10
screws
.
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamp. Mount and evenly tighten the four screws
Guideline
Screw, handlebar clamp
M6
15 mm (0.59 in)
3.5 mm (0.138 in)
. Remove the handlebar clamp. Remove the handlebar
. Remove the handlebar support.
M10
40 Nm
(29.5 lbf ft)
M8
53
.
10 Nm (7.4 lbf ft)
.
apart.
from the center.
Loctite
®
243™
.
20 Nm
(14.8 lbf ft)
Advertisement
Table of Contents
