Removing The Main Silencer; Installing The Main Silencer; Glass Fiber Yarn Filling Of Main Silencer; Removing The Glass Fiber Yarn Filling Of The Main Silencer - KTM 125 EXC EU 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Removing the main silencer

11.87
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.

Installing the main silencer

11.88

Glass fiber yarn filling of main silencer

11.89

Removing the glass fiber yarn filling of the main silencer

11.90
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.
2 0 0 2
–
Remove screws
–
Pull the main silencer off of the manifold at the rubber sleeve
B00036-10
–
Mount the main silencer with rubber sleeve
–
Mount and tighten screws
Guideline
Remaining screws, chassis
B00036-11
The main silencer is filled with glass fiber yarn
Over a period, the fibers of the insulating material vanish into the air, and the silencer
"burns out".
Not only is the noise level higher, the performance characteristic changes.
B00063-10
–
Remove the main silencer. (
–
Remove nut
0 0 1 1
–
Remove the locking cap and outer tube
–
Pull the glass fiber yarn filling
–
Clean the parts that are to be reinstalled.
0 0 3 3
B00037-10
.

.

x
p. 80)
.


from the inner tube.

.

.

M6 10 Nm (7.4 lbf ft)
.

.
80