MAINTENANCE WORK ON CHASSIS AND ENGINE
Adjusting the chain guide
11.45
–
Loosen nut
–
Loosen nuts
–
Adjust the chain tension by turning the adjusting screws
Guideline
Chain tension
Turn adjusting screws
and right chain adjusters are in the same position relative to reference marks
The rear wheel is then correctly aligned.
–
Tighten nuts
–
Make sure that chain adjusters
–
Tighten nut
Guideline
Nut, rear wheel spindle
Info
The wide adjustment range of the chain adjusters (32 mm) enables different
secondary ratios with the same chain length.
Chain adjusters
400225-10
–
Remove the motorcycle from the work stand. (
x
(XC)
–
Loosen screw
Condition
Number of teeth: ≤ 44 teeth
–
Insert collar bushing
–
Mount and tighten screw
Guideline
Condition
Number of teeth: ≥ 45 teeth
–
Insert collar bushing
–
Mount and tighten screw
Guideline
400224-10
.
.
on the left and right so that the markings on the left
.
are fitted correctly on adjusting screws
.
can be turned by 180°.
. Remove screw
in hole
. Tighten screw
Remaining screws, chassis
in hole
. Tighten screw
Remaining screws, chassis
to the left and right.
8... 10 mm (0.31... 0.39 in)
M20x1.5
80 Nm (59 lbf ft)
p. 38)
. Swing the chain guide down.
. Position the chain guide.
.
M6
10 Nm
(7.4 lbf ft)
. Position the chain guide.
.
M6
10 Nm
(7.4 lbf ft)
57
.
.