Storage; Putting Into Operation After Storage - KTM 125 EXC EU 2010 Owner's Manual

Hide thumbs Also See for 125 EXC EU 2010:
Table of Contents

Advertisement

STORAGE

Storage
14.1
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
Avoid contact between fuel and skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse immedi-
ately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed, con-
tact a doctor immediately. Change clothing that has come into contact with fuel. Store fuel in a suitable canister according
to regulations and keep it out of the reach of children.
Info
If you want to put the motorcycle into storage for a longer period, take the following actions.
Before storing the motorcycle, check all parts for function and wear. If service, repairs or replacements are necessary, you
should do this during the storage period (less workshop overload). In this way, you can avoid long workshop waiting times at the
start of the new season.
Clean the motorcycle. (
Change the gear oil.
(
x
Check the antifreeze and coolant level. (
Drain the fuel from the tank into a suitable container.
Empty the carburetor float chamber.
Check the tire air pressure. (
(250 EXC AUS/XC‑W/XC, all 300 models)
Remove the battery.
x
(250 EXC AUS/XC‑W/XC, all 300 models)
Recharge the battery.
Guideline
Storage temperature of battery without direct sunlight
Store the vehicle in a dry location that is not subject to large fluctuations in temperature.
Info
KTM recommends jacking up the motorcycle.
Jack up the motorcycle. (
Cover the vehicle with a tarp or cover that is permeable to air.
Info
Do not use non-porous materials since they prevent humidity from escaping, thus causing corrosion.
Avoid running the engine for a short time only. Because the engine will not warm up sufficiently, the water vapor produced
during combustion will condense, causing engine parts and the exhaust system to rust.

Putting into operation after storage

14.2
Remove the motorcycle from the work stand. (
(250 EXC AUS/XC‑W/XC, all 300 models)
Install the battery.
x
Refuel. (
p. 33)
Perform the checks before putting into operation. (
Make a test ride.
p. 93)
p. 88)
p. 77)
(
p. 87)
x
p. 70)
(
p. 72)
(
p. 72)
x
p. 38)
p. 38)
(
p. 72)
p. 31)
0... 35 °C (32... 95 °F)
94

Advertisement

Table of Contents
loading

Table of Contents