Installing The Front Wheel - KTM 125 EXC EU 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Installing the front wheel

11.63
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
–
Holding the front wheel, withdraw the wheel spindle. Take the front wheel out of
the fork.
Info
Do not pull the hand brake lever when the front wheel is removed.
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
500085-10
–
Remove spacers
500086-10
x
–
Clean and grease shaft seal rings
Long-life grease (
–
Insert the spacers.
500086-11
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Operate the hand brake lever several times until the brake linings are lying correctly
on the brake disc.
–
Remove the motorcycle from the work stand. (
500084-11
–
Pull the front wheel brake and push down hard on the fork several times to align
the fork legs.
–
Tighten screws
Guideline
Screw, fork stub
.

and bearing surface

p. 132)
.

M24x1.5
.

M8
of the spacers.

45 Nm
(33.2 lbf ft)
p. 38)
15 Nm
(11.1 lbf ft)
67