Table of Contents
Advertisement
MAINTENANCE WORK ON CHASSIS AND ENGINE
Refilling with coolant
x
11.86
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
–
Avoid contact between coolant and skin, eyes and clothing. If it gets into your eyes, rinse immediately with water and con-
tact a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor immedi-
ately. Change clothes that have come into contact with coolants. Keep coolant out of the reach of children.
(All 125/150/200 models)
–
Make sure that screw
–
Stand the motorcycle upright.
–
Fill the radiator completely with coolant.
Coolant
B00071-10
–
Loosen screw
Replace and retighten screw
Guideline
Remaining screws, engine
B00091-10
(All 250/300 models)
–
Make sure that screw
–
Stand the motorcycle upright.
–
Fill the radiator completely with coolant.
Coolant
B00072-10
–
Position the vehicle as shown and secure it against rolling away. A height differ-
ence of
Guideline
Height difference
Info
To ensure that all of the air can escape from the cooling system, the
0 0 A
A
front of the vehicle must be jacked up. A poorly bled cooling system is
less effective at cooling and may result in overheating of the engine.
400677-10
–
Place the vehicle back on a level surface.
–
Fill the radiator completely with coolant.
–
Mount radiator cap
–
Run the engine until it is warm.
–
Check the coolant level. (
B00073-10
is tightened.
1.2 l (1.3 qt.)
until coolant that does not contain any bubbles escapes.
.
is tightened.
1.2 l (1.3 qt.)
must be reached.
.
p. 77)
Coolant (
p. 130)
Coolant (mixed ready to use)
(
p. 130)
M6
10 Nm
(7.4 lbf ft)
Coolant (
p. 130)
Coolant (mixed ready to use)
(
p. 130)
75 cm (29.5 in)
79
Advertisement
Table of Contents
