Table of Contents
Advertisement
MAINTENANCE WORK ON CHASSIS AND ENGINE
Removing the rear brake linings
11.59
Warning
Danger of accident Brake system failure.
–
Maintenance work and repairs must be carried out professionally. (Your authorized KTM workshop will be glad to help.)
Installing the rear brake linings
11.60
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents Reduced braking efficiency due to use of non-approved brake linings.
–
Brake linings available from accessory suppliers are often not tested and approved for use on KTM vehicles. The construc-
tion and friction factor of the brake linings and therefore the brake power can differ considerably from the original KTM
brake linings. If brake linings are used that differ from the originals, there is no guarantee that they comply with the origi-
nal license. The vehicle no longer corresponds to the condition at delivery, and the warranty is no longer valid.
x
–
Press the brake caliper onto the brake disc by hand in order to push back the brake
piston.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
–
Remove locking split pins
–
Clean the brake caliper and brake caliper support.
400236-10
x
–
Check the brake discs. (
–
Check that leaf spring
caliper support are seated correctly.
Info
The arrow on the leaf spring points in the rotation direction of the brake
disc.
500122-10
–
Insert the brake linings, insert bolt
Info
Make sure that the decoupling plate
brake lining.
–
Operate the foot brake lever repeatedly until the brake linings lie on the brake disc
and there is a pressure point.
400237-10
, withdraw bolt
, and take out the brake linings.
p. 58)
in the brake caliper and sliding plate
, and mount locking split pins
is mounted on the piston side of the
65
in the brake
.
Advertisement
Table of Contents
