Displaying And Maintaining The Tftp Client; Tftp Client Configuration Example - 3Com 4500G Family Configuration Manual

Follow these steps to configure the TFTP client:
To do...
Enter system view
Use an ACL to control the
device's access to TFTP
servers
Configure the source address
of the TFTP client
Return to user view
Download or upload a file in an
IPv4 network
Download or upload a file in an
IPv6 network
If no primary IP address is configured on the source interface, no TFTP connection can be
established.
If you use the ftp client source command to first configure the source interface and then the
source IP address of the packets of the TFTP client, the new source IP address will overwrite the
current one, and vice versa.

Displaying and Maintaining the TFTP Client

To do...
Display the configuration of the
TFTP client

TFTP Client Configuration Example

Network requirements
As shown in
addresses are 1.2.1.1/16 and 1.1.1.1/16 respectively. An available route exists between Device
and PC.
Use the command...
system-view
tftp-server [ ipv6 ] acl
acl-number
tftp client source { interface
interface-type interface-number
| ip source-ip-address }
quit
tftp server-address { get | put |
sget } source-filename
[ destination-filename ]
[ source { interface
interface-type interface-number
| ip source-ip-address } ]
tftp ipv6 tftp-ipv6-server [ -i
interface-type
interface-number ] { get | put }
source-file [ destination-file ]
Use the command...
display tftp client
configuration
Figure 3-2, use a PC as the TFTP server and Device as the TFTP client. Their IP
—
Optional
By default, no ACL is used to
control the device's access to
TFTP servers.
Optional
A device uses the source
address determined by the
matched route to communicate
with the TFTP server by
default.
—
Optional
Available in user view
Optional
Available in user view
Available in any view
3-3
Remarks
Remarks