imagistics cm4530 User Functions Manual page 114

2.SETTING GENERAL FUNCTIONS (Cont.)
7
Place the printed chart face down on the
glass with its bottom toward you and its
top left aligned against the original scale
on the left side, in order that the black line
be placed at the left side.
8
Press the [START] button.
- After scanning the printed chart, following message is displayed:
[Apply Calibration Setting?]
4
If the chart is not properly placed, the message "Set chart correctly"
is displayed on the touch panel. In this case, go back to step 7 and
place the chart again.
9
Press the [YES] button to apply the
calibration setting, or press the [NO]
button to cancel the calibration setting.
112
4.SETTING ITEMS (ADMIN)