Keithley 2000 User Manual page 253

Table D-2 (cont.)
Models 8840A/8842A device-dependent command summary
Mode
Trigger mode
T0 (default)
Offset (Rel)
Display
Suffix
Terminator
Clear
Single-trigger
GET
Models 196/199 and 8840A/8842A Commands
Command Description
Trigger
mode
Internal
T1 External
T2 External
T3 External
T4 External
Note: Delay is enabled by entering EXT TRIG mode while in
local.
B0 Offset off (default)
B1 Offset on
D0 Normal display (default)
D1 Blank display
Y0 Disable output suffix (default)
Y1 Enable output suffix
W0 Enable CR LF EOI (default)
W1 Enable CR LF only
W2 Enable CR EOI only
W3 Enable CR only
W4 Enable LF EOI only
W5 Enable LF only
W6 Enable EOI only
W7 Disable all output terminators
* Device clear (resets 8842A to default conditions)
X0 Clear error register
? Trigger measurement
G0 Get instrument configuration (function, range, speed,
trigger)
G1 Get SRQ mask
G2 Get calibration input prompt (generates error message
51)
G3 Get user-defined message (replies with 16 space charac-
ters)
G4 Get calibration status (replies with "1000")
G5 Get IAB status (input F/R, autorange on/off, offset on/
off)
G6 Get YW status (suffix enabled/disabled, terminator
selection)
G7 Get error status
G8 Get instrument ID
(replies with "FLUKE,8842A,0,EMUL")
Rear panel Auto
trigger delay
Disabled —
Enabled On
Disabled On
Enabled Off
Disabled Off
D-7