Keithley 2000 User Manual page 160

5-22 SCPI Command Reference
:CALCulate2
:FORMat <name>
CALCulate2:FORMat <name>
Parameters
Query
Description
:STATE <b>
:CALCulate2:STATe <b>
Parameters
Query
Description
These commands are used to configure and control the CALC2 operations on
readings stored in the buffer.
<name> = NONE
MEAN
SDEViation Standard deviation of readings in buffer
MAXimum Largest reading in buffer
MINimum
:FORMat? Query programmed math format
This command is used to specify the format for the CALC2 math calculation.
The calculation operations for CALC2 use data stored in the buffer.
With NONE selected, no CALC2 calculation is performed. With any of the
other formats selected and CALC2 enabled (see :STATe), the calculation is
performed every time the :IMMediate or :IMMediate? command is executed.
<b> = 0 or off
1 or on
:STATe? Query state (on or off) of CALC2.
This command is used to enable or disable the CALC2 calculation. When
enabled, the selected CALC2 format will be calculated when the :IMMediate
or :IMMediate? command is executed.
Specify CALC2 format
No calculations
Mean value of readings in buffer
Lowest reading in buffer
Control CALC2
Disable CALC2 calculation
Enable CALC2 calculation