Keithley 2000 User Manual page 159

:MUNits
:CALCulate [1]:KMATh:MUNits <name>
Parameter
<name> = 3 characters using 'A' through 'Z'
Query
:MUNits?
Description
This command is used to specify the units data element for the mx+b calcu-
lation. Use any three letters from 'A' through 'Z'.
:PERCent <NRf>
:CALCulate [1]:KMATh:PERCent <NRf>
Parameter
<Nrf> = -1e8 to +1e8 Specify target value.
Query
:PERCENt?
Description
This command is used to specify the target value for the percent calculation.
:ACQuire
:CALCulate [1]:KMATh:PERCent:ACQuire
Description
This action command is used to acquire the present input signal reading and
use it as the target value for the Percent calculation.
:STATe <b>
:CALCulate [1]:STATe <b>
Parameters
<b> =
Query
:STATe?
Description
This command is used to enable or disable the CALC1 calculation. When
enabled, each instrument reading will reflect the selected calculation (see
:FORMat).
:DATA?
:CALCulate [1]:KMATh:DATA?
Description
This query command is used to read the result of the CALC1 calculation. If
CALC1 is disabled or NONE is selected, the "raw" reading will be read.
SCPI Command Reference
Specify units for mx+b
Query units for mx+b
Specify target value for percent calculation
Query percent target value
Use input signal as target value
Control CALC1
0 or off Disable CALC1 calculation
1 or on Enable CALC1 calculation
Query state (on or off) of CALC1.
Read CALC1 result
5-21