Hold Command - Keithley 2000 User Manual

:HOLD Command

:WINDow <NRf>
[:SENSe[1]]:HOLD:WINDow <NRf><name>
Parameter
Query
Description
:COUNt <NRf>
[:SENSe[1]]:HOLD:COUNt <NRf>
Parameter
Query
Description
:STATe <b>
[:SENSe[1]]:HOLD:STATe <b>
Parameters
Query
Description
The following commands are used to configure and control the Hold feature.
For details on Hold, refer to "Trigger Model, Device Action" in this section
and "Hold" in Section 3.
<NRf> = 0.01 to 20 Set window (percent)
:WINDow? Query Hold window.
This command is used to set the window for Hold. The window is expressed
as a percent of the "seed" reading for the Hold process.
<NRf> = 2 to 100 Specify Hold count
:COUNt? Query Hold count.
This command is used to specify the count for Hold. Count is the number of
readings that are compared to the "seed" reading during the Hold process.
<b> = 0 or OFF
1 or ON
:STATe? Query state of Hold.
This command is used to enable or disable Hold. See "Hold" in Section 3 and
"Trigger Model, Device Action" in this section for details on Hold.
SCPI Command Reference
Set Hold window
Specify Hold count.
Control (on/off) Hold
Disable Hold
Enable Hold
5-39