ENCAD 215319-1 User Manual page 82

later a single beep should be heard, indicating the download was successful.
After a one second delay, the printer will automatically reboot. The printer
should come up normally. Verify the new firmware revision by sequencing
through Utility Menu - Service Menu - About menu.
3. If multiple beeps are heard, reboot printer and reseat serial port connection.
Resend the .ROM file to the printer.
Print Quality
Many of the print quality concerns can be resolved by priming, cleaning, and calibrating
the cartridges. When this is the case, "Prime, clean, calibrate, or replace" is indicated
with other solutions. Refer to the following chapters for details:
Prime - see Quick Start Guide
Clean - see Maintenance Guide
Calibrate - see Quick Start Guide
Replace - see Maintenance Guide
No print appears
Check that tape has been removed from the printhead of the cartridge.
White lines or large gaps on print or portions of characters missing
Prime, clean, calibrate, or replace cartridges.
Check if the ink reservoir is empty. Refill if necessary.
Make sure the media feeds freely.
Overall print quality is poor
Prime, clean, calibrate, or replace cartridges.
Make sure the printer is positioned on level ground.
Use a higher quality print mode.
Be sure you are using the correct inks and media.
Cartridge spits small amounts of ink on paper
Nozzle plate may be flooded. Try using a lower firing rate or replacing the cartridge.
CADJET ® 3D User Guide
Troubleshooting F-8