ENCAD 215319-1 User Manual page 63

Paper Option Menu
l Supply Type
l
Media Standard
l
Margins
l Auto-Load Delay
Supply type
Media standard
Margins
Auto-Load Delay
Auto-Cut
Save Media
Auto-Wipe
Exit
Auto-Cut
Save Media
Auto-Wipe
Exit
provides access to a further menu to select the supply type: roll or
sheet.
provides access to a further menu to select the media standard: All,
US_Engr, US_Arch, ISO_A, Met over A, ISO_B, Special, Graphics,
US_All, Met_All.
provides access to a further menu to change the available plot area
based on the margin type elected. Select Normal or Expanded
margins.
provides access to a further menu to change the delay between when
the media is positioned for loading and when loading occurs. This
allows users to adjust the media if necessary. Select 1-12 seconds.
Default = 6.
provides access to a further menu to turn Auto-Cut Off or On. When
On, the printer cuts the media after printing is complete.
provides access to a further menu to turn Save media On or Off.
When set to On, printing will stop at the end of the image rather than
scrolling out the full paper size.
provides access to a further menu to turn the Auto-wipe function, On
or Off. When On, the cartridges are wiped during printing.
returns to the Setup menu.
l
l
l
l
CADJET ® 3D User Guide
Menu Tree C-6