ENCAD 215319-1 User Manual page 79

Check the shaft for visible damage (carriage moves back and forth on it during
operation).
Clean the shaft with a lint free cloth and isopropyl alcohol (let it dry completely
before trying to operate the printer).
Check the belt for visible damage such as fraying and pieces coming off it.
Check the trailing cable (cable that moves during printer operation) for visible dam-
age.
Check whether the idler assembly (located at the left end of the belt) moves freely.
Check whether it is cracked or broken.
Cannot draw ink during initial siphon
Check that the quick release fitting connection to the ink reservoir is secure.
Check whether contaminants have blocked the ink delivery lines. If necessary, flush
the lines with distilled water, then reprime.
Initial siphon cannot be established
Check that ink reservoirs are full.
Check ink delivery system for leaks in the lines, at the tubing connection, and at the
quick connect coupling to the reservoir. If leaks cannot be stopped, call Technical
Support.
Ink cartridges do not fire properly
Be sure that cartridges and the service station are cleaned periodically to maintain
good print quality. (See the Maintenance Guide.)
Cartridges may wear out after extended use. Try replacing the cartridge.
Store cartridges in a sealed container at room temperature when not in use for ex-
CADJET
3
Troubleshooting F-5
® 3D User Guide