ENCAD 215319-1 User Manual page 74

Error Message
Unrecognized cartridge
Cartridge end of life attained.
Unrecognized ink type.
To clear the error, turn the printer off and then on again. Press Utility/Service Menu/
Cartridge Info to determine the cartridge for which the error message is displayed.
Press Utility Menu/Access Cartridges to move the carriage to the position which
allows replacement of the ink cartridges. Check to make sure you have the correct
cartridge for your printer model installed in each position, that they all contain the same
type of ink and all cartridges are installed properly. Install new cartridges if necessary.
Corrective Action
Be sure the cartridge is the correct cartridge for
your printer model. Your printer will not work with
cartridges from other models. Remember, the
printer is reading the value programmed into the
chip on the cartridge, it is not actually detecting the
cartridge type. Replace the cartridge if necessary.
Replace cartridge. You can check cartridge status
by choosing Cartridge Info from the Service menu.
Cartridge usage is displayed in milliliters. The
display changes in 2ml increments. 290ml indicates
that the cartridge should be replaced. When 300ml
is displayed, the cartridge will stop functioning.
Be sure the cartridge is the correct cartridge for
your printer model. Your printer will not work with
cartridges from other models. Ink type information
is stored on the cartridge chip. If you are using a
new type of ink which has been introduced since
you purchased your printer, you will need to
upgrade the printer's firmware to accommodate the
new ink type.
CADJET ® 3D User Guide
Error messages E-2