The following parameters will not affect nesting:
To enable nesting
From the main menu, press Setup Menu/HPGL/2 menu/Nesting
1
Menu.
On the Nesting menu, choose Nest On or Off and press OK.
2
Nest wait time
Nesting Wait Time is the amount of time the printer waits for the next plot to fill
the current nest.
The printer will begin printing whenever the printer has been idle for the speci-
fied time interval. The time is reset whenever a print job is received.
To define nesting wait time
From the main menu, press Setup Menu/HPGL/2 menu/Nesting
1
Menu.
On the Nesting menu, choose Nest/On and press OK.
2
On the Nesting menu, choose Nest Time.
3
On the Nest Time menu, choose the Nest Time (30 seconds, 1
4
minute, 2 minutes) and press OK.
• Ink limiting;
• Replots;
• If Auto Rotation is enabled, then the nesting algorithm is free to rotate
the plot if it determines that doing so will save media. Plots are sequen-
tially fitted across the page from right to left; and
• The HPGL/2 EC command can be used to control cutting. If any plot in
a nest has the cutter enabled, the plotter will cut after the nest.
®
CADJET
3D User Guide
HPGL/2 4-6