ENCAD 215319-1 User Manual page 55

6 Carefully disconnect the ribbon cable
from the connector on the PC board
and the other two cables that go to the
cover.
Á
To remove the SIMMs
1 Facing the top of the SIMMs, push the
side clips gently to the outside (away
from the SIMM).
2 Push over and pull out, being careful
not to damage the fingers on the top.
Á
To install the new SIMM
1 Insert at a 45 degree angle and slowly push the SIMM to a 90
until the two side clips snap into place. Make sure the SIMM is fully
seated.
2 Carefully reconnect the ribbon cable harness to the connector on the
PC board. Reattach the other connectors removed earlier.
3 Reinstall the right cover and top cover.
®
CADJET 3D User Guide
o
angle
Installing additional memory A-2