Table of Contents
Advertisement
8-38 System Upgrade
Removing PCI Board
To remove PCI board card, follow the reverse procedure of the installation and install the expansion
slot cover.
Replacing PCI Board
Follow the procedure below to replace the failed PCI board.
<Other than N8803-038 Fibre Channel Board Set>
1.
Check the failed board from the event log.
2.
Remove the CPU/IO module referring to the page 8-12.
3.
Remove the PCI bracket, then remove the PCI board.
4.
Replace the board and fasten it.
5.
Install the CPU/IO module referring to the page 8-12.
6.
Connect the network cable and cables for PCI boards.
7.
The installed CPU/IO module will start automatically.
8.
Confirm that the PCI board is correctly recognized by POST and OS.
＜N8803-038 Fibre Channel Board set＞
1.
Check the failed board from the event log.
2.
Remove the CPU/IO module referring to the page 8-12.
3.
Configure WWPN of HBA (setting/confirming access control) newly installed on control
software such as iStorageManager.
4.
Remove the PCI bracket, then remove the PCI board.
5.
Replace the board and fasten it.
6.
Install the CPU/IO module referring to the page 8-15.
7.
Connect the network cable and cables for PCI boards.
8.
The installed CPU/IO module will start automatically.
9.
Confirm that the PCI board is correctly recognized by POST and OS.
Advertisement
Table of Contents
Troubleshooting
