NEC N8800-162F User Manual page 81

Stop the operation of a PCI module using the ft server utility.
3.
Move to the directory where the NEC ESMPRO Agent is installed.
# cd /opt/nec/esmpro_sa/bin
Start the ft server utility.
# ./ESMftcutil
The screen of the ft server utility will appear.
Select [ftServer] - [PCI Module] - [PCI Module (to be removed)]. The screen of the PCI
Module(to be removed) will appear.
Select [PCI Module Start/Stop] - [Stop] to the stop of the PCI .Module.
* As for the primary PCI module (*), if the PCI module 0 is primary, select [PCI
Module(ID:10)]. If the PCI module 1 is primary, select [PCI Module (ID:11)].
When you stop the operation of the primary PCI module, a failover occurs and the
secondary PCI module becomes the primary module.
ft server utility
The following events or changes occur when stopping the primary PCI module and the
module fails over:
The screen temporarily blacks out and then displayed again.
Indications of PCI modules' status LEDs change as follows:
[Indications of the status LEDs]
1 PRIMARY LED
2 DISK ACCESS LED
3 System FT LED
LED
LED
Linux Setup and Operation 3-13
PCI Module
Secondary
-
-
when accessing to
System
-
Primary
Green
Amber or Green
blinking (Green
HDD)