Start And Stop Of Components - NEC N8800-162F User Manual

5-38 Installing and Using Utilities

Start and Stop of Components

To start or stop a component with NEC ESMPRO Manager, use the [Maintenance] tree of the
component in the [ft] tree of the DataViewer. Open the tree of the component to be started or
stopped and select the [Maintenance] tree.
To start or stop a component with the ft server utility, use the utility screen of the component.
The table below shows the common cases in which a component is to be started or stopped.
Compo-
nent
Remote
CPU When the cause of
Module down is reviewed
and the system is
restarted in module
down state.
Executable in any of
the following module
states (this can be
viewed on manager
screen):
•
Removed
•
Broken
•
Shot
•
Firmware Update
Complete
•
Diagnostics
Passed
PCI Module Same as above
Remote: Executable from remote management PC by using NEC ESMPRO Manager
Local: Executable on local server by using ft server utility
–: Not supported
IMPORTANT: PCI modules, SCSI adapters, SCSI buses, and modules under the SCSI
enclosure have impact on each other. You need to be aware of this, for example, when you
replace a PCI module. For details, see "Impact When Module Status Changes" described
earlier in this chapter.
Start
Local
When the cause of
down is reviewed
and the system is
restarted in module
down state.
Executable in the
following module
state:
•
When the status
LED 1 is amber
and the status LED
2 is off
Only the status LED
illuminates amber
when the module is
in one of the
following states:
•
Removed
•
Broken
•
Shot
•
Firmware Update
Complete
•
Diagnostics
Passed
Same as above
Stop
Remote
When system is
stopped forcibly
due to replacement
or malfunction of
module.
Executable in the
following module
state (this can be
viewed on manager
screen):
•
Duplex
Same as above
Local
When system is
stopped forcibly
due to replacement
or malfunction of
module.
Executable in the
following module
state:
•
Only the green
LED is on and in
redundant
configuration
state
The both green
LEDs are on when
the module is in the
following state:
•
Duplex
Same as above