NEC N8800-162F User Manual page 97

Boot
To change the boot order of devices connected to the server
Select [Boot] and specify the boot order.
To display POST check results
Select [Advanced] - [Boot-time Diagnostic Screen] - [Enabled].
You can also press Esc while the NEC log is on the screen to display POST check results.
To control from the HW console
Remote operation via Serial
Select [Server] - [Console Redirection], and make necessary settings.
To use Remote wake up function
Select [Advanced] - [Advanced Chipset Control] - [Wake on LAN] - [Enabled].
Memory
To check the installed memory (DIMM) status:
Select [Main] - [System Memory] and [Extended Memory] and check the status indications.
Saving the Configuration Data
To save the BIOS configuration data
Select [Exit] - [Exit Saving Changes]
To discard changes to the BIOS configuration data
Select [Exit] - [Exit Discarding Changes]
To restore the default BIOS configuration data (the data may differ from the factory preset)
Select [Exit] - [Load Setup Defaults].
System Configuration 4-7